Page 137

Libroplantasingl

GLOSSARY OF EQUIPMENT 136-137 useful width will be 15 cm less than the total width. In general for any type of belt the minimum useful width must be greater than 2 times the maximum size of the materials transported by it, measured along at least two of their three dimensions, such that they are not wedged into the space between the lips of the sides of the belt so no undesired jams occur. In specific belts for manual sorting and separation the useful width must not exceed 1.4 m, provided there are sorting positions on both sides of the belt, and if there are only sorting operators on one side of the belt they must not exceed 0.7m, so that all materials can be reached by them. • Provide the cross-section adapted to the objective (manual sorting, transport or process). • Length of the conveyor belt. The length and slope of a conveyor belt are determined by the implementation requirements. • Cleaning system. Conveyor belts have a scraper fitted near the drive rotor for cleaning materials attached to the belt. This system cannot be used in belts with ribs, which require the use of brushes or periodic cleaning. For this reason, ribbed belts are not recommended for transporting fine materials. 5. Chute for transfer between belts at 90º. LIGHT WEIGHT PACKAGING SORTING PLANTS INLET BELT 1 VERTICALLY HINGED TAILGATE SCRAPER LOAD CENTERING DEFLECTOR BELT 2 5 5


Libroplantasingl
To see the actual publication please follow the link above